PYLE Audio PCM60A - Manual (Page 5)

Pyle Home PCM60A Manual - 4
SPEAKER CONNECTION
One or more speakers (4, 8 or 16 Ohms) can be connected to the amplifier with or
without transformers. However, before you connect any speakers to the amplifier, the
total impedance must be calculated in order to avoid damage to the amplifier. A total
speaker impedance greater than 16 Ohms or less than 4 Ohms can cause this damage
to occur.
SYSTEM 1 : Single Speaker System
NOTE : Connect the speaker (+) to the amplifier's 4-Ohm, 8-Ohm or 16-Ohm terminal,
depending on the speaker being used.
SYSTEM 2 : Two (or more) Speakers in Series
NOTE : Connect the speaker (+) to the amplifier's 4-Ohm, 8-Ohm or 16-Ohm terminal,
depending on the TOTAL IMPEDANCE of the two speakers. If each speaker
has an impedance of 8-Ohm, the total speaker impedance in this series
cofiguration is 16 ohms.