Pitney Bowes Integra N300 - Manual (Page 2)

2
Locate
the plug
ports
under the
front of the scale
and plug in the small end
of the power cord.
4
If you're
using a
Pitney Bowes
meter, plug the small end of the scale-meter
interface cable into the scale port.
6
Level the scale by turning the scale feet until
the leveling bubble is centered and the scale
does not wobble.
7
8
Lift the
platter,
remove the
packing
material,
and replace
the platter on the scale.
Tuck the
cord(s)
under the
guides on the
bottom of the
scale.
9
If you're using a Pitney Bowes meter, connect
the large end of the scale-meter interface
cable to your meter's communications port.
Tighten the thumbscrews securely. See the
meter's operating guide for the location of
the port.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
;;
;;
Remove packing. Level the scale.
Bubble must
be in center.
Adjustable
Feet (4)
Locate the plug ports.
Connect scale-meter interface
cable to scale.
Tuck the cords under the
guides.
Connect scale-meter interface
cable to meter.
5
or