Pioneer DV-400V-S - Manual (Page 31)

USB playback 06
31
En
Chapter 6
USB playback
Using the USB interface
It is possible to listen to two-channel audio and
watch JPEG files using the USB interface on
the front of this unit. Connect a USB mass
storage device as shown below.
Note
• This includes playback of MP3/WMA/
MPEG-4 AAC/JPEG files (except files with
copy-protection or restricted playback).
• Compatible USB devices include portable
flash memory (particularly keydrives) and
digital audio players (MP3 players) of
format FAT16/32. It is not possible to
connect this unit to a personal computer
for USB playback.
• Pioneer cannot guarantee compatibility
(operation and/or bus power) with all USB
mass storage devices and assumes no
responsibility for any loss of data that may
occur when connected to this unit.
• With large amounts of data, it may take
longer for the system to read the contents
of a USB device.
• The Home Menu cannot be displayed
while using the USB mode.
1 With the player switched on, press
DVD/USB.
Make sure your TV is on and set to the correct
video input, and that
USB MODE is showing
on the front panel display.
2 Connect your USB device.
The USB terminal is located on the front panel.
• Disc Navigator is automatically displayed.
3 Press ENTER to start playback.
• The method of playback for files saved on a
USB device is the same as for other discs.
For more information, see
Basic playback
controls on page 21 and Playing discs on
page 24.
4 Turn off this player and remove the
USB device.
• The next time you turn this player on it will
start up in USB mode. To return to DVD
mode, either press
DVD/USB or press
OPEN/CLOSE to open the disc tray.
Important
If a USB ERR message lights in the display, it
may mean that the power requirements of the
USB device are too high for this player, or that
the device is incompatible. Try the following:
• Switch the player off, then on again.
• Reconnecting the USB device with the
player switched off.
• Change the player back to DVD mode
( LOADING will appear in the front panel
display whether a disc is inserted or not) by
pressing
DVD/USB , then once again
select USB mode ( USB MODE will appear
in the front panel display).
• Using a dedicated AC adapter (supplied
with the device) for USB power.
If this doesn’t remedy the problem, it is likely
your USB device is incompatible.
USB DVD/USB HDMI
STANDBY/ ON
USB mass
storage device
USB
(Type A)
DV400V_KUC_EN.book 31 ページ ２００７年３月１４日 水曜日 午後８時８分