Basic setup 04 – Pioneer VSX 920 User Manual

Page 32

Basic Setup

Press

on the remote control,

then press the SETUP button.
An on-screen display (OSD) appears on your
TV. Use

/// and ENTER on the remote

control to navigate through the screens and
select menu items. Press

RETURN to exit the

current menu.

• Press

SETUP at any time to exit the System

Setup menu.

Select ‘Auto MCACC’ from the System

Setup menu then press ENTER.

Try to be as quiet as possible after pressing
ENTER. The system outputs a series of test
tones to establish the ambient noise level.

Follow the instructions on-screen.

• Make sure the microphone is connected.

• Make sure the subwoofer is on and the

volume is turned up.

• See below for notes regarding background

noise and other possible interference.

Wait for the test tones to finish.

A progress report is displayed on-screen while
the receiver outputs test tones to determine the
speakers present in your setup. Try to be as
quiet as possible while it’s doing this.

• For correct speaker settings, do not adjust

the volume during the test tones.

Confirm the speaker configuration.

The configuration shown on-screen should
reflect the actual speakers you have.

• With error messages (such as

Too much

ambient noise) select RETRY after
checking for ambient noise (see Other
problems when using the Auto MCACC
Setup on page 33).

If the speaker configuration displayed isn’t
correct, use

/ to select the speaker and

/ to change the setting. When you’re
finished, go to the next step.

If you see an error message (

ERR) in the right

side column, there may be a problem with the
speaker connection. If selecting

RETRY

doesn’t fix the problem, turn off the power and
check the speaker connections.

Note

1 The screensaver automatically starts after three minutes of inactivity. If you cancel the Auto MCACC Setup at any time, the

receiver automatically exits and no settings will be made.

MIC IN blinks when the microphone is not connected to MCACC SETUP MIC.

RECEIVER

System Setup

1.Auto MCACC

2.Manual SP Setup
3.Input Assign
4.Speaker System
5.Video Parameter

Return

1.Auto MCACC

Now Analyzing

Environment Check
Ambient Noise
Speaker YES/NO

Return

1.Auto MCACC

Check!

Return

10:Next

Front
Center
Surr
Surr. Back
Subwoofer

[ YES ]
[ YES ]
[ YES ]
[YESx2]
[ YES ]

VSX-920_UCSMXCN_En.book 32 ページ２０１０年１月２１日　木曜日　午前９時４３分