Philips DVR2104 User Manual
Page 25
17
period of time.
7. Alert upload: the system will automatically stop uploading when it
reaches the set time.
8. Auto-inspect the sentries time: after setting it, the video recording will
output an alert in the set time. It has to be cleared by hand. It is used to
check whether the guard is on duty and whether the video recording is
working well.
9. Alert
linkage
:
it is to set the function parameter of the alert interface as
following:
1. Alert: (three options) alert input alert output, and alert number.
2. Interface: with two options, open and close. The default is open.
3. Alert
linkage
: to choose the alert input number.
4. Degree: to set the priority of alert (1 to10). No 1 is the lowest degree.
5. Recording picture: correspond to the picture of alert input.
6. Quality: quality of alert picture.
7. Output: it is alert output.
8. Buzzer: it is the switch of buzzer. The default is close, which means the
alert outputs without any sound.
9. Upload: to set whether the alert picture is upload or not. The default is
close. (Optional)
10. Pre-setting: to get the default back.
11. Save and back: press it after setting.
12. Back: back without save the setting.
13. After setting all the above parameters, presses
“cancel” and “save” or
continue to set other parameters (by choosing
“last page”/”next page”)
14. Attention: after save the setting and canceling the menu, the user has to
press
“guard” in the front panel, so that the alert will function.
PDF 文件使用 "pdfFactory Pro" 试用版本创建