Patton electronic 2300M - Manual (Page 10)

10
3. Connect the dual fiber ST or SC connectors on the media converter
(see Figure 3) directly to the 802.3 compliant multi-mode fiber cable
equipped with male ST or SC connectors or via 802.3 compliant
multi-mode fiber patch cord (not provided) and corresponding ST or
SC fiber wall jacks.
Note Verify that the cable connecting the TX and RX of the 2300M
Series unit is connected to the RX and TX respectively on the
remote 2300M Series unit or network device. End-to-end multi-
mode fiber connections between two Model 2300M Series
Ethernet Media Converters or between one Model 2300M
Series Media Converter and other network devices must not
exceed 2 km (1.24 miles), 298.7 m (980 ft) in 100Base-SX mode
(Model 2311M only).
Figure 3. Fiber connector locations
4. Connect the DC power output side of the power supply adapter to
the power jack (see Figure 1 on page 8) on the 2300M Series unit.
5. Connect the AC power side/cord of the power supply adapter to the
appropriate AC power source.
The media converter will power up and LED indicators will illuminate
once connected to the power source.
Gaithersb
urg, Mar
yland
Model 2311M
Auto-Negotiating Ether
net
Media Con
ve rter
10/100Base-T/TX to 10/100Base-FL/SX
PWR
FO100
FO
AC T
FO10
TP100
TP AC
T
TP10
ST or SC style
fiber connectors