Philips FW65C - Manual (Page 9)

9
English
General Information
• The typeplate (which contains the serial number)
is located at the rear of the system.
• Recording is permissible if copyright or other
rights of third parties are not infringed.
• This device complies with the Federal
Communications Commission (FCC) rules, part 15
and with 21 CFR 1040.10. Operation is subject to
the following two conditions:
– This device may not cause harmful
interference, and
– This device must accept any interference
received, including interference that may
cause undesired operation.
Environmental Information
All unnecessary packaging has been omitted. We have
tried to make the packaging easy to separate into three
materials: cardboard (box), polystyrene foam (buffer) and
polyethylene (bags, protective foam sheet).
Your system consists of materials which can be recycled
and reused if disassembled by a specialized company.
Please observe the local regulations regarding the disposal
of packaging materials, exhausted batteries and old
equipment.
Accessories (Supplied)
– Remote control
– Batteries (two x AA size) for remote control
– AM loop antenna
– FM antenna wire
– AC power cord
– One pair of Surround Speakers
(FW386C and FW65C
only)
Safety Information
• Before operating the system, check that the operating
voltage indicated on the typeplate (or the voltage
indication beside the voltage selector) of your system is
identical with the voltage of your local power supply. If
not, please consult your dealer. The type plate is located
at the rear of your system.
• When the system is switched on, do not move it around.
• Place the system on a solid base (e.g. a cabinet).
• Place the system in a location with adequate ventilation
to prevent internal heat build-up in your system.
• Do not expose the system to excessive moisture, rain,
sand or heat sources.
• Under no circumstances should you repair the system
yourself, as this will invalidate the warranty!
• If the system is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture may
condense on the lens of the CD unit inside the system.
Should this occur, the CD player will not operate
normally. Leave the power on for about one hour with no
disc in the system until normal playback is possible.
• Electrostatic discharge may cause unexpected problems.
See whether these problems disappear if you unplug the
AC power cord and plug it in again after a few seconds.
• To disconnect the system from the power supply
completely, remove the AC power plug from the
wall socket.
CONTENTS GENERAL INFORMATION SAFETY INFORMATION
General Information ................................................... 9
Safety Information ...................................................... 9
Preparation ......................................................... 10 - 11
Controls ............................................................... 12 - 13
Remote Control ......................................................... 14
Operating The System ...................................... 14 - 15
CD ......................................................................... 16 - 18
Tuner .................................................................... 18 - 20
Tape ...................................................................... 20 - 21
Aux .............................................................................. 21
Recording ............................................................ 22 - 23
Clock ........................................................................... 24
Timer .................................................................... 24 - 25
Maintenance ............................................................. 25
Specifications ........................................................... 26
Troubleshooting ........................................................ 27