Maintenance – Polaris Outlaw 9921488 User Manual
Page 162
159
Maintenance
Daytime Running Lights Lamp Replacement
If the daytime running lights do not operate, replace the lamps. Polaris recommends that you
install replacement lamps obtained from your authorized Polaris dealer.
1. Disconnect the lights from the harness.
2. Remove the rubber cover from the back of the light assembly.
3. Press the lamp retainer inward and turn it counter-clockwise to remove it. Note the posi-
tion of the lamp positioning tab, then carefully pull the lamp out.
4. Install the new lamp. Make sure the filament is horizontal.
5. Reinstall the lamp retainer. Press the retainer inward and turn it clockwise about 1/4 turn.
6. Start the engine to make sure the lights come on. If the lights do not operate, see your
Polaris dealer for service.
7. Reinstall the rubber cover, and reconnect the lights to the harness.
- 2005 ATV Sportsman 90 2005 ATV Predator 50 2005 ATV Predator 90 2006 ATV Predator 50 2006 ATV Predator 90 2006 ATV Sportsman 90 Sprotsman 90 Predator 50 2000 ATV Universal ATV 1998 ATV Scrambler 500 Offroad Vehicle Sprotsman 700 Scrambler 50 2003 ATV Predator 90 Predator 9920872 2007 ATV Outlaw 90 2007 ATV Sportsman 90