Patton electronic 12168 - Manual (Page 10)

10
3.2 RACK CARD INSTALLATION
The Model 1068 rack card version comprises a front card and a rear
card.Do the following to install the cards into the rack chassis:
1. Slide the rear card into the back of the chassis along the metal rails.
2. Secure the rear card using the supplied metal screws.
3. Slide the front card into the chassis until you feel resistance as the
front card engages the rear card. When that happens, gently push
the front card forward until it is fully seated in the card-edge recepta-
cle of the rear card (it should
click into place).
4. Secure the front card using the captive fasteners.
Note The Model 1001R14 chassis supports “hot swapping” of cards,
so it is not necessary to power down the rack when you install or
remove a Model 1068 rack card.
Figure 3. Model 1068 rack cards
5. Connect the line interface between the units (refer to section 3.3,
“Connecting the Twisted-Pair Line Interface” on page 11)
Note See Figure 3 for the rack card’s panel arrangements.
PO
TS/ISDN
1068DRC
1068DVRC
POTS/ISDN
Port
VLINK
RJ-45 interface
VLINK
terminal block
VLINK
RJ-45 interface
VLINK
terminal block
VLINK
VLINK
Ether
net
Ethernet
Port
Ethernet
Port Ether
net