Platinum Vanities APS-997C - Manual (Page 17)

128-8774
17 of 24
Page 17
ADDITIONAL REMOTE FEATURES:
The two way remote control unit allows you to access status
information from the vehicle, check temperature, light the
display, toggle the transmitter from beep tones to vibrate
mode, initiate daily start timer, and temperature start. Selec-
tion of these and other features are shown below:
NOTE: Transmitter must be within operating range of the
vehicle, approximately 1000 ft.
Check Vehicle Status:
Press the lock+key+option buttons simultaneously for 1
second. The vehicle's alarm will display the systems current
status.
Check Temperature: (Only available on certain remote start units)
Press the option+key buttons simultaneously for 1 second.
The vehicle's alarm will display the temperature. Temperature is read from the
alarm's module located below the dashboard. This reading may be higher than
actual ambient temperature due to the greenhouse and is relative only to the
inside vehicle temperature.
Temperature Start Mode: (Available on certain models)
To toggle this feature on or off, from the armed mode, press the Option &
Unlock Buttons simultaneously, the temperature icon appear on, or disappear
from the display, and the transmitter will emit a tone.
NOTE: This feature must be active in the feature selection menu of your system.
Check with your installing dealer to insure this feature is set to the on position.
Light The Display:
Press and release the "F" (Function) button one time. The display will illumi-
nate for 10 seconds.
Vibrate Or Tones:
Press the "F" and unlock buttons simultaneously to toggle this feature on and
off.
Daily Start Timer: (Only available on certain remote start units)
24 Hour Start Timer. Standing at the vehicle at the time you want it to
start, press the option + lock buttons simultaneously for 1 seconds. The
transmitter will beep and display the 24 hr timer. This is the time the
vehicle will start when you follow the exit procedure. In other words, if you want
the vehicle to start 6AM, at 6AM of any morning, standing at the vehicle, press
and hold the option + lock buttons until you hear a beep and the 24 hr timer is
displayed. This establishes a starting time. The unit will start at the prescribed
time once only. This function must be selected each time you want the vehicle
to start. To activate this function, (a) Turn the ignition switch off. (b) Within 10
seconds of step (a), depress and hold the brake pedal, while pressing the key
icon transmitter button 2 times. (c) the unit will emit 2 chirps, the transmitter will
beep and the start timer icon on the display will remain on. The vehicle will start