Platinum Vanities APS-997C - Manual (Page 15)

128-8774
15 of 24
Page 15
NOTE: Engine can be started in many modes armed,
disarmed, valet, etc... The screen shown is Locked/
Armed and running.
When the Panic Mode has been activated and the
system is armed the vehicle's lights will flash, the siren and lock icon will be
displayed on the LCD screen and the siren will beep. If the system is disarmed
and the Panic Mode is activated, the lights will flash unlock icon
will be displayed and the siren will beep on the LCD screen.
When ever the vehicle is operated from the two way transmitter,
the unit will beep responsive to the function executed at the
vehicle. 1 beep when armed, 2 beeps when disarmed, etc... at
times It may be inconvenient or too noisy to hear the beep tones,
so the system allows you to set the unit for vibrate mode. To
toggle on or off beep tones/vibrate, Simultaneously press the "F"
and unlock buttons. The icons shown left will appear in the upper
left hand corner of the screen to indicate vibrate..
If the alarm system has been triggered, the icon displayed on the transmitter
LCD will indicate which zone has been activated, as well sound the beep
tones, or vibrate dependent upon the setting as shown above. The following
trigger patterns will be displayed.
Triggered and the entry attempt was made to one of the
vehicle Doors.
Triggered and entry attempt was made to the vehicles Hood
or
Trunk.
Triggered and entry attempt was made to the vehicles glass, or
the vehicle has been hit or bumped hard enough to cause a
response from the vibration detector.
ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:
If the arm/disarm chirp tones have been turned off at the
vehicle, when you arm, or disarm, the display will indicate this as
shown and there will be no arm/disarm chirps at the transmitter.
This is true if the transmitter is set for vibrate mode.