Pioneer VSX-72TXV - Manual (Page 67)

Using other functions 10
67
En
The front panel display shows each of the following
settings for two seconds each:
2 When you’re finished, press STATUS again to
switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel AV
PARAMETER button, press and hold STANDBY/ON
for about three seconds.
The display shows RESET?.
3 Press the front panel ENTER button.
The display shows RESET OK?.
4 Press SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Input source Listening mode
Signal select Surround Back Processing
Video Select MCACC Position
Room 2 / REC SEL Room 3
Setting Default
HDMI Audio Amp
Digital Video Conversion On
Speakers A
Surround Back System Normal (SBch)
Speaker System Front SMALL
Center SMALL
Surr. SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
Bass Peak Level OFF
X-Curve OFF
THX Audio Setting 0–1ft.
Inputs
See Input function default and possible settings on page 62.
Multi Room
Room 2 Volume Type Variable
Room 2 IR Receiver Type SETTING 1
Room 2 Volume -60
SR+
SR+ Control On/Off OFF
SR+ Volume Control On/Off OFF
Monitor Out OFF
DSP
MCACC Position Memory M1: MEMORY 1
Surround back channel
Processing ON
Phase Control On
Sound Delay 0 frame
Dual Mono CH1
DRC OFF
SACD Gain 0 dB
Digital Safety OFF
Effect Level 7 ch Stereo 90
Other modes 70
PL II Music Options Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image 3
All Inputs Listening Mode (2 ch) AUTO SURROUND
Listening Mode (x ch) AUTO SURROUND
Listening Mode (HP) STEREO
See also Setting the AV options on page 64 for other default DSP
settings.
MCACC
Channel level (M1–M6) 0 dB
Speaker Distance (M1–M6) 10 ft
Standing Wave
(M1–M6) Standing Wave On/
Off ON
ATT 0 dB
SWch Wide Trim 0.0
EQ Data (M1–M6) All channels/bands 0 dB
EQ Wide Trim (M1–M6) 0.0 dB
Setting Default