Pioneer VSX-72TXV - Manual (Page 31)

Using the tuner 06
31
En
Saving station presets
If you often listen to a particular radio station, it's
convenient to have the receiver store the frequency for
easy recall whenever you want to listen to that station.
This saves the effort of manually tuning in each time. This
receiver can memorize up to 30 stations, stored in three
banks, or classes, (A, B and C) of 10 stations each. When
saving an FM frequency, the MPX setting (see page 30) is
also stored.
1 Tune to a station you want to memorize.
See Listening to the radio on page 30 for more on this.
2 Press T.EDIT (TUNER EDIT).
The display shows STATION MEMORY, then a blinking
memory class.
3 Press CLASS to select one of the three classes then
press ST / to select the station preset you want.
You can also use the number buttons to select a station
preset.
4 Press ENTER.
After pressing ENTER, the preset class and number stop
blinking and the receiver stores the station.
Naming station presets
For easier identification, you can name your station
presets.
1 Choose the station preset you want to name.
See Listening to station presets below for how to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows STATION NAME, then a blinking
cursor at the first character position.
3 Input the name you want.
Choose from the following characters for a name up to
four characters long.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!”#$%&’() ∗ +,–./:;<=>?@[ \ ]^_{|} ˜
• Use the ST
/ buttons (remote) to select
characters.
• Press ENTER to confirm a character. If no character
is input, a space is input.
• The name is stored when ENTER is pressed after
choosing the fourth character.
Tip
• To erase a station name, simply repeat steps 1-3 and
input four spaces instead of a name.
• Once you have named a station preset, you can press
DISP when listening to a station to switch the display
between name and frequency.
Listening to station presets
You will need to have some presets stored to do this. See
Saving station presets
above if you haven’t done this
already.
1 Press TUNER to select the tuner.
2 Press CLASS to select the class in which the station
is stored.
Press repeatedly to cycle through classes A, B and C.
3 Press ST
/ to select the station preset you want.
• You can also use the number buttons on the remote
control to recall the station preset.
SLEEP ANALOG VIDEO
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
DVD SAT VIDEO 1 TV CONT
DVR1 i Pod TUNER RECEIVER
CD TV VIDEO 2
XM RADIO ROOM2/3 DVR2 CD-R
+10 DISC
CLASS D.ACCESS
ENTER
TV CONTROL
VOL
TUNE
TUNE
ST ST
TV CH INPUT
SELECT
REC
TV VOL
ENTER
AV PARAMETER
TOP MENU ì
DTV MENU
CH LEVEL
MENU
T.EDIT
BAND
RETURN SETUP
CATEGORY
GUIDE
SHIFT
STATUS
MCACC S.DIRECT
MULTI OPE
SIGNAL SEL SBch STEREO
MEMORY MPX
AUDIO SUBTITLE
ADV. SURR STANDARD
PHASE
THX
DTV INFO MUTE REC
REC STOP
HDD
CH CH
DVD
DISP