Polaroid PDM-1040 - Manual (Page 17)

17
Installation Steps
Follow the steps below to install the battery.
Step1:
Pull the battery holder out from the remote
control in the direction of the arrow.
Step 2:
Load a new battery properly with
the (+) sided up.
Step3:
Insert the battery holder back into
the original position.
Battery Property
Battery Type:
CR2025 3V
Battery Life: Approximately 1 year under normal use (at room temperature).
Caution
1. Improper use of the battery may cause overheating, explosion or ignition, which can
result in an injury or a fire. Battery leakage may damage the remote control.
2. Do not expose the remote control unit to direct sunlight.
3. Do not recharge, disassemble, deform or heat the battery.
4. Do not put the battery in fire or water.
5. Replace an exhausted battery immediately.
Remote Control