Philips 105B2 User Manual
Page 26
Select
under Advanced Controls in the monitor 's OSD. Most computers require it to be set at 0.7V.
Please review the following for possible solutions:
If the OSD menu is also dim, please contact service for repair
●
Reset the monitor via the OSD menu
●
Change the color temperature settings to 9300 color coordination via the OSD menu
●
Set the Contrast to maximum level (100) and Brightness to middle level (50)
●
Video card could be defective (try the monitor with another computer)
45. I have noticed two thin horizontal lines on the screen of my Philips monitor. Is this
normal?
This phenomenon can occur with Philips 107P, 109P and 201P monitors and is normal. Your
monitor is using an Aperture Grille, which consists of fine vertical wires to align the electron
beams with the phosphors on the screen. To prevent these vertical wires from vibrating and to
keep them properly aligned with the picture tube, two horizontal damper wires are required.
These are located on one-third and on two-third from the top of the screen. The result is that
you will see two very thin horizontal lines over your screen since the two wires are casting a
slight shadow on the screen surface. You will find these wires (line) in any monitor from Philips
and other brands using the Aperture Grille technology.
46. How can I increase the color display of my monitor?
The amount of video memory your video card holds determines the amount of colors that can
be displayed on your computer screen. To get the most out of your video card, you will need to
either install the latest drivers onto your computer or upgrade the video cards memory. Please
check with your computer or video card manufacturer for further details.
47. Why is there no picture on my monitor?
Check the wall socket for power. Verify that there is power by connecting another
product.
●
Ensure the power cable is correctly attached to both the wall socket and the monitor.
●
Check that the power button is switched on.
●
Unplug the monitor for approx. 1 minute and plug it in again. Switch the monitor back on.
●
48. Why is there no picture on my monitor even though the power LED is
yellow/amber?
Frequently Asked Questions
file:///D|/EDFU/LF3/lf3manual/english/FAQ.HTM (11 of 12) [2002/9/2 ?? 04:08:32]