Precor Electronic Console with the Pulse Feature 903 - Manual (Page 9)

page 9
904 Assembly Procedures
To install the 904 electronic console, take the following steps:
1. Remove the handrail clamp from its box. Take the long and
short screws out of the handrail clamp using your fingers or
a Phillips head screwdriver. Set the screws aside.
2. Position the handrail clamp over the right handrail’s
micro-adjustment knob as shown in Diagram 6. Place
a hand on either side of the handrail clamp to gently
pull it apart so that you can slide it onto the handrail’s
foam grip and into position (about 8 inches above the
base of the foam grip).
Important: Do not mount the clamp on the painted surface
of the handrails.
Diagram 6