Precor Electronic Console with the Pulse Feature 903 - Manual (Page 7)

page 7
5. Secure the mounting bracket and clamp by inserting the
two long screws through the mounting holes. You may
need to squeeze the ends of the clamp together to install
the screws. See Diagram 3. Tighten the screws into the
recessed holes on the mounting plate using the Phillips
head screwdriver. Do not over tighten the screws. A gap
should remain between the opposite sides of the handrail
clamp.
Diagram 4
6. Unwrap the reed switch wire. Route the connector and
wire through the hole in the handrail clamp. See
Diagram 4.
7. Plug the connector into the receptacle as shown in
Diagram 4. Do not force the connection. The
connector is designed to engage in one direction only.
A tab on the connector and a slot on the receptacle
help you determine the proper alignment.
8. Align the back of the console with the mounting
bracket and slide the electronic console onto it. Gently
pull the excess wire through the hole in the handrail
clamp while you slide the console toward the rear of
the treadmill.