Philips DECT 121 User Manual

Page 5

Installing your DECT 121

1. Plug the power supply & line cord into the base

station.

2. Plug the power supply & line cord into the wall

socket. Always use the cables provided in the

box.

3. Slide open the battery compartment cover.

4. Place the 2 batteries as indicated. Respect

polarity.

5. Slide the battery compartment cover back.

6. Put the handset on the base and charge for 24

hours. A beep indicates that the handset is

properly placed on the base unit or the charger.

If you have a broadband DSL internet

Installation, please make sure you have one

DSL filter plugged directly on each line

socket used in the house and check the

modem and the phone are plugged in the

correct filter slot (one specific for each)

When replacing the batteries, only use

rechargeable NiMH batteries. Optimal

battery life is reached after 3 cycles of

full charge / discharge. The warranty

shall not apply to the batteries and any

other components within lifetime and

wear. Standby time: around 100 hours

Talk time: around 10 hours.

DECT121(180105).pmd

02/02/2005, 22:44