Polaris Sportsman 9922247 - Manual (Page 76)

72
MAINTENANCE
Oil and Filter Change
Oil Pump Priming
This priming procedure must be
performed whenever the oil hose
connection between the oil tank and
pump inlet has been disconnected.
1. Clamp or pinch off the vent line
approximately 2" (5 cm) from
the oil tank, between the end of
the oil tank vent fitting and the
vent line's pressure relief slit.
2. Start the engine. Allow it to idle
for 10-20 seconds.
3. Remove the vent line clamp. If the line is bled properly, you should
hear a rush of air, indicating that the line is properly primed and
ready for operation.
Tip: If you do not hear air, the line has not bled. Repeat the priming procedure.
Clamp
Pressure
Relief Slit
Tank
2"
(5 cm)