Philips TP3697B1 - Manual (Page 41)

41
LOCATOR POWER
AV ON/OFF POSITION FREEZE TV
VCR
ACC
SWAP SOURCE PIP CH
UP DN
SMART
SOUND
SMART
PICTURE
MENU SURF
VOL CH
MUTE
CC STATUS CLOCK A/CH
EXIT TV/VCR
SLEEP TUNER
VCR
RECORD
A/B
MULTI
MEDIA INCREDIBLE
STEREO
06
07
08
09
06
07
08
09
1
3
4
3
07
08
09
2
S
ETTING THE
R
EMOTE
C
ONTROL
T
O
W
ORK
W
ITH
O
THER
D
EVICES
Y our TV remote can be set to
work various external devices
such as VCRs, Cable Boxes,
Satellite Receivers, DBS, DVD,
etc. by what is called the search
method of remote control pro-
gramming.
If the “Remote Code” number
method shown on the previous
page did not set your remote to
work your external device, then
follow the easy steps listed below.
Please read steps 1-4 before
beginning.
Press the POWER button on
the device your are attempting to
program to turn ON.
Place the TV/VCR/ACC
Mode Switch in the proper posi-
tion.
Press the VCR RECORD
and the SMART SOUND but-
tons simultaneously and hold
them down.
The device will begin to
change channels after the remote
identifies the correct code. When
the channels start to change
release the VCR RECORD and
SMART SOUND buttons. The
remote should be ready to oper-
ate the device.
Cable Converter
S MART H ELP
This method can take up to
two minute to preform.
Don’t let the device scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search cycle
will have to be repeated.
If no channel change happens within
two minutes, repeat steps 1-4.
Should a channel change still not
occur, the remote will not work the
desired device.
BEGIN
Satellite Receiver,
DBS, DVD, or
similar device
VCR
Search Method