Peavey VSX 26 - Manual (Page 17)

17
Comments
Audio Channels 3 inputs/6 outputs RTA Mic input can be summed with
Line inputs.
LED metering 2 inputs/6 outputs LED STATUS:
Red = -0.5 dBFS and higher (Clip)
Red & Green = -4 to -0.5 dBFS
Green = -4 to -40 dBFS
Off = below -40 dBFS
mute Function Front panel switch and LED for each input and
output
LED STATUS:
Red = Muted
Off = On
ANALOG INPUTS
Input Trim Range -6 to +6 dB Software controlled
Line Sens Settings +24 dBu or -10 dBV Software selectable
Line Input Impedance 4.4 k ohms Electronically balanced
Line max In 24 dB
Line Input CmRR 55 dB
Line Input Crosstalk -90 dB 20 Hz to 20 kHz
Line Input Dynamic Range 110 dB A-weighted 150 ohm input termination
RTA mic Gain Range +20 to +60 dB Approximately 1/2 dB steps
RTA max In +2 dBu (.98Vrms) Gain = 60 dB, 22K BW
RTA Input Impedance 2.2 k ohm Electronically balanced
RTA Input CmRR 55 dB
RTA Input EIN -128 dB A-weighted 150 ohm input termination
RTA Phantom Power +48 volts Software controlled
AES Input On XLR 1 Software selectable between left
channel analog line input
OUTPUTS
Output Full Scale +24 dBu Balanced
Output Impedance 150 ohms Electronically balanced
minimum Load Impedance 600 ohms Maximum output @ 600 ohms =
22.5 dBu
Dynamic Range 105 dB A-weighted
ANALOG INPUT-TO-OUTPUT
Total Harmonic Distortion
(+ Noise)
0.007 % 20 Hz to 20 kHz, 22 kHz BW filter,
+4 dBu signal with 20 dB headroom
Frequency Response 20 Hz to 20 kHz ± 0.5 dBr referenced at 1 kHz
Dynamic Range 105 dB A-weighted, 150 ohm input
termination
Latency < 1 mS Propagation delay from input to
output
vSX
™
26
SPECIFICATIONS