Porter-Cable RS830 - Manual (Page 14)

14
TABLE BOARD CLAMPS
AND TABLE BOARDS
1. Locate table board clamps (A) Fig. 29, and insert
one clamp into each of the slotted holes (B) located at
the rear of each table support bracket (C) as shown in
Fig. 30.
Fig. 29
Fig. 30
Fig. 31
Fig. 32
2. Turn adjusting screw (D) Fig. 30 counter clockwise,
so that the knobs (A) are in the rear position as shown.
3. Place 1-1/4" wide board (E) Fig. 31, against front
table board (G), and 5-3/4" wide board (J) against 1-1/4"
wide board (E), place the 1-3/4" wide board (H) in the
upright position against the 5-3/4" wide board (J) as
shown. Then tighten knobs (D), until the table boards are
securely clamped in position.
ADJUSTING
AND CHECKING
SAW BLADE TRAVEL
SQUARE TO FENCE
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Raise track arm (A) Fig. 32, by turning elevating
handle (B) until the blade (C) can be assembled on the
motor shaft. Then tighten arbor nut (D) using the
wrenches supplied.
3. Place a framing square (E) Fig. 32, against fence (H)
as shown, and lower track arm (A) until the blade just
clears the table surface.
A
B
C
A
D
A D
B
A
H
E D
C
G
E
J
D
H