Philips DC185 - Manual (Page 10)

TUNER
1 Press SOURCE repeatedly to switch on the radio (FM only).
™ Display shows the radio frequency of the last selected waveband. Your pre-
set station is also shown if you are listening to a preset.
2 Adjust the sound using VOLUME -/+.
3 To select preset stations, press PRESET -/+ once or repeatedly.
TUNING TO RADIO STATIONS
1 Press and hold ¡1/2™ until the frequency in the display starts changing.
™ After the system tunes to a station of sufficient reception, display shows its
frequency.
• To tune to a weak station, press ¡1/2 ™ briefly and repeatedly until an
optimal reception is found.
To improve reception (FM):
Extend and position the pigtail fully to obtain optimum reception.
Manual programming
You can store up to 20 FM radio stations in the memory.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2 Press MODE to activate the programming, and then press PRESET -/+ to select a
desired preset number.
3 Press MODE again to confirm.
4 Press PRESET -/+ to listen to a preset station.
Automatic programming
1 Press and hold MODE for more than two seconds.
™Available radio stations will be automatically stored.
DOCK
By connecting the iPod to your DC185, you can listen to the music stored in iPod
player through the powerful speakers of the set.
IFU_DC185_12_eng 2008.7.24 4:03 PM Page 10