Philips SE6580B/37 - Manual (Page 2)

2. Register the handset.
You must register your handset to the base station before you can use it. Place
Handset on Base unit is displayed on the handset screen. The PIN is required before
you can register or unregister handsets. By default, the PIN is 0000.
Easy registration
This type of registration is available when you wish to register your SE6580 on a SE650,
SE655 or SE658 base station. For any other Philips base station, please refer to “Manual
Registration” below. Moreover, the PIN code of the base station has to be the default
one, that is 0000. If you have already changed it, please refer to base station user guide
to reset it to default 0000 or refer to Manual Registration below.
1. Insert the unregistered handset into the base station to automatically begin
registration.
2. Registering… is displayed on the screen.
• Upon successful registration, a validation tone is emitted on the base (except for
SE650) then on the handset, and the handset number (1 to 8) will be assigned by
the base automatically.
• If the easy registration fails, please refer to “Manual Registration” below.
Manual registration
1. Power on the handset.
2. On the base station, press and hold handset locator
a for 3 seconds. A beep
sounds to indicate that the base station is ready to accept registration. (No beep
sounds on the SE650.)
If no action is taken on the handset within 90 seconds, the registration procedure will
be aborted. If this happens, repeat from Step 1.
3. On the handset, press m, scroll n to Advanced Set and press o Select .
4. Scroll n to Register and press o Select .
5. Enter the PIN when prompted and press o OK to confirm.
Registering… is displayed on the screen.
• Upon successful registration, a validation tone is emitted and the handset number
(1 to 8) is assigned by the base station automatically.
This procedure is valid for Philips base stations. For other brands of base stations,
please refer to base station user guide.
Note
Note
What’s in the box
Handset with belt clip Charger Battery door
2 AAA rechargeable
batteries
Power supply User manual
Guarantee Do Not Return leaflet Quick Start Guide
WARNING: Always use the power supply and batteries that came with your phone.
1
Connect
Connect the charger
2 Install
1. Insert rechargeable batteries and charge.
1. Place the charger near a power outlet.
2. Connect the power cable to the connector on the charger.
3. Connect the other end of the power cable to the power outlet.
Insert batteries Charge handset for 24 hours A B