Panasonic CU-C24DKU - Manual (Page 3)

ENGLISH
3
TEMP
MODE
POWERFUL
AIR SWING
FAN SPEED
ECONOMY
1
2
3
TIMER
ON
OFF
CANCEL
SET
COOL
AUTO
AUTTO
AUTO
FAN
RESET CLOCK
OFF/ON
QUIET
����� �������� ������� ����� �����
TEMP
MODE POWERFUL
AIR SWING
FAN SPEED
QUIET
1 2 3
TIMER
ON
OFF CANCEL
SET
COOL
AUTO
AUTO
AUTO
FAN
RESET CLOCK
OFF/ON
• Timer operation will be based on current
time set.
• The batteries can be used for
approximately 1 year.
• The batteries must be recycled or
disposed of properly.
Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subject to change without notice for future improvement.
PRODUCT OVERVIEW
Air intake
Airflow direction
louver
Air filter
Front panel
Indoor Unit
Outdoor Unit
Air inlet (rear)
Air outlet
LCD display
Temperature setting
Powerful operation
Memory reset
Clock setting
Economy operation
Operation mode
Quiet operation
Airflow direction
adjustment
Timer setting
Off/On
Fan speed selection
Remote Control
Indicator
Air
Purifying
filter
Auto OFF/ON
button
Receiver
Transmitter
Air inlet (side)
Discharged
air
• Make sure it is not obstructed.
• Maximum distances : 10m.
• Certain fluorescent lights may interfere
with signal transmission. Consult your
dealer.
Remote Control Preparation
■
About
Remote Control Signal
Auto OFF/ON Button
1. Pull
out
2. Insert batteries
(AAA or R03)
3. Press CLOCK button
4. Set
current
time
5. Press again to confirm
Troubleshooting
●
Operation delayed for a few minutes after restart.
➤ This is a normal self protection function.
●
Sound like water flowing during operation. ➤ Caused by refrigerant flow inside.
●
Mist emerges from indoor unit. ➤ Condensation effect due to cooling process.
●
Noisy during operations.
➤ Installation work could be slanted or front panel isn’t closed properly.
●
Remote control/display does not work.
➤ Check whether batteries are correctly inserted or need replacement.
●
The unit cannot operate. ➤ Check whether circuit breaker is tripped or timer is being used correctly.
●
Outdoor unit emits water/steam. ➤ Condensation or evaporation has occurred at piping surface.
• To operate the unit if the remote
control is misplaced or malfunctioning.
Action
Operation
mode
Press once
Automatic
Operation
Press until “beep”
sound
Cooling
Operation
• To turn OFF, press the Auto OFF/ON
button again.
• To switch the remote control signal
receiving sound off or on.
1. Press until you hear a “beep” sound
and release.
2. Press again until you hear a “beep-
beep” sound and release.
3. Press to switch the sound off or on.
(Long “beep” - OFF; short “beep”
- ON)