Philips FW-C72 - Manual (Page 13)

3139 116 19521 (ENG)
13 OPERATING THE SYSTEM
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
To start the demonstration mode
• Press and hold Ç(on the system
only) for five seconds when the
system is in standby mode.
™ The demonstration will begin.
Easy Set
EASY SET allows you to store all
available radio stations automatically.
• Press and hold STANDBY ON (on
the system only) for five seconds
when the system is in standby or
demonstration mode.
™ “EASY SET” will be displayed,
and followed by “ TUNER” and
then “ AUTO”.
™ EASY SET will start searching for
all radio stations on FM band and
then followed by radio stations on
AM band.
™ All available radio stations with
sufficient signal strength will be
stored. Up to 40 presets may be
stored.
Notes:
– EASY SET will start with the FM band,
if there are still presets available, the
system will continue to store the AM
band.
– When EASY SET is used, all previously
stored radio stations will be replaced.
– The last preset radio station will
appear on the display when EASY SET
is completed.
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT
PLAY buttons.
Switching the system to
standby mode
• Press STANDBY ON or B on
the remote control.
™ The system will switch to standby
mode.
™ (for model FW-C72 only)
About five seconds later, the
system will go into an energy
saving mode if the demonstration
mode has been disabled.
Selecting the Source
• Press the respective source selection
button: CD, TUNER, TAPE or
AUX.
™ The display indicates the selected
source.
Note:
– For an external source, make sure you
have connected the audio left and right
OUT terminals of the external
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the
AUX/CDR IN terminals.
Selecting the Equalizer
Display
You can select the desired equalizer
display for the system. You must not
press the DSC or INCREDIBLE
SURROUND (for model FW-C71 only)
button on the system before using the
JOG control.
• Adjust the JOG control to select the
desired Equalizer Display, NORMAL,
TOP DOWN, or NITE MODE.
™ The selected display will be
shown.
NORMAL Display
FRONT FM
STEREO BACK HSD REPEAT REC LW MW AM T.A. NEWS TIMER
60Hz 500Hz 250Hz 1KHz 2KHz 4KHz 8KHz
SHUFFLE PROGRAM
TOP DOWN Display
FRONT FM
STEREO BACK HSD REPEAT REC LW MW AM T.A. NEWS TIMER
60Hz 500Hz 250Hz 1KHz 2KHz 4KHz 8KHz
SHUFFLE PROGRAM
NITE MODE Display
60Hz 500Hz 250Hz 1KHz 2KHz 4KHz 8KHz
FRONT FM
STEREO BACK HSD REPEAT REC LW MW AM T.A. NEWS TIMER SHUFFLE PROGRAM
Note:
– In NITE MODE, all lights will be
switched off and the display brightness
will be dimmed.
pg 01-27/C71-C72/37-Eng 12/16/99, 1:20 PM 13