Philips Candlelight Set HF8430 - Manual (Page 11)

using the appliance
Massager
1 Press any button to switch on the massager (Fig. 6).
The light ring goes on.
The massager starts operating in the default mode (mode 1) and at
moderate vibration speed.
Tip: We advise you to start in the default mode. You can gradually increase
the vibration speed once you are familiar with the options.
Note: If you feel uncomfortable during use, you can adjust the vibration
speed. See step 3.
Press the mode selection button to adjust the vibration to your
own preference (Fig. ).
The appliance has 5 vibration modes (A to E) that activate up to 3
vibration spots placed in the tip (1), the top (2) and the bottom (3)
of the massager (Fig. 8).
a Tip motor runs, vibration is focused on one point
B Tip and bottom motors run in turn
c Top and bottom motors run in turn
D Tip and top motors run in turn
E All motors run in turn
Press the increase or decrease button one or more times to adjust
the vibration speed of the massager to your own
preference. (Fig. 9)
The appliance has 5 speed levels.
You can hold the massager in different ways. Experiment to find the
most comfortable way to use the massager.
Tip: For suggestions, consult the welcome booklet.
Tip: You can also use the massager in combination with a water-based or
silicon-based lubricant or massage oil. Do not use scented and/or alcohol-
based lubricants or massage oils, as they may cause damage.
,
,
-
EnglisH 11