Precision Power PC6800 - Manual (Page 7)

Before beginning, disconnect the negative (-) terminal of the
battery prior to working on the positive (+) terminal to prevent
a short to ground. This is important, unless you want to spend
the rest of your life with a nickname like
"Sparky," or "Smokey."
Reconnect the negative terminal only after all connections have
been made.
5
W a r n i n g !
Fuse must be installed within 18" of battery
eject
VOLUME BASS TREBLE RIGHT LEFT BALANCE TRACK REVERSE FOWARD
1 2 3 4 8 7 6 5 PPI MAR KET ING DPT
Trk 1
Fuse must be
installed within
18" of battery
Drill a hole in the firewall
and use a rubber grommet
to keep wire from shorting.
Run the cables under the
carpet near the side of the
vehicle. Be careful not to
drill or screw into the wires
when you replace the trim.
Run signal cables (RCAs)
and remote turn-on lead
down the opposite side of
the vehicle of the power
wire to avoid radiated noise.
Firmly attach Amp
Ground Wire to solid
metal (see page 6).
Avoid sharp edges that
could chafe through the
insulation.
Positive
Battery
Terminal
Factory Ground wire may
need to be replaced if it is
frayed or broken.
For systems over 300 watts,
add a ground cable from the
amp to the battery
(see page 6).
WIRING
BACK TO CONTENTS