PYLE Audio PTA3 - Manual (Page 4)

2
8. SWITCHABLE MIC PAGER AND MIXING MODES
-Set to PAGER, allows a voice to be heard clearly through
the microphone by attenuating automatically all the
audio input sources. This is good to use when paging the
person in office, store, or restaurant.
-Set to MIXING, both of the voices from microphone and
music will be existed at the same time. It is similar like
playing at KARAOKE events.
9. 1/4" MIC INPUT JACK
-Lets you connect a microphone with a 1/4" plug.
10. AUX1/AUX2/CD RCA INPUT
-Lets you connect most high-level audio sources such as
CD player, tape deck, tuner, camcorder or VCR.
11. REC RCA OUTPUT
-Lets you connect the amplifier to a tape deck for
recording.
12. SPEAKER L/R TERMINALS
-Lets you easily connect speaker wires directly to the
amplifier.Speaker impedance can range from 8 to 4 ohms
for the general stereo output. please see the next
instruction of using four 8-ohm speskers for stereo mode
connection.
13. VOLTAGE SELECTOR
-Lets you select the voltage of AC power input source. The
amplifier has selectable input voltage from 110v/60Hz
which is the standard in USA and CANADA. You can also
switch the input voltage to 230V/50Hz for EUROPEAN
opeation. Please make sure the switch is in the proper
position before operating, otherwise severe damage will
result not cover by the warranty. Please also replace the
fuse with proper rating in this situation (see the next
instruction for the fuse rating).
14. FUSE
-The amplifier uses a fuse for protection against surges
and short circuit. If the amplifier suddenly turns off and
will not turn on, check the fuse, If necessary, replace it with
a
1.5-amp, 250-volt, fast-acting, 5 x20mm fuse (not supplied).
15. Blue LED output level display