PLUS Vision V3-131 - Manual (Page 24)

E-24
Power Cable Connections and Switching the Power On/Off
Finishing
1
Switch off the power of the connected equip-
ment
2
Switch off the power of the projector
Press the STANDBY button.
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen
will go off (in about 5 seconds) and the projector will enter the
power-off operation.
Note:
Do not stow away the lens unit while projecting an image. Doing so
could damage the projector. If the lens unit has been stowed away
while projecting an image, the STATUS and STANDBY indicator’s flash
orange and the projector is automatically turned off.
Note:
* The operation can be cancelled by pressing a button other than the
STANDBY button.
* One more press of the STANDBY button will switch off the power.
The STANDBY indicator changes to flashing amber and lights a
steady amber after about 90 seconds (when the unit enters the
standby mode).
Flashing amber
(Approximately 90
seconds)
Lit amber
Standby mode
3
Unplug the power cable
Check that the STANDBY indicator is lit in amber and then
unplug the power cable.
The STANDBY indicator will go off when the power cable is un-
plugged.
Warrning
Do not unplug the power cable while the STANDBY indicator is flashing amber. Doing so may shorten the life of the lamp
or damage the projector.
Power Off
OK ?
STANDBY STATUS STANDBY STATUS STANDBY STATUS
Lit green
RGB
STANDBY
VIDEO
FREEZE MUTE ECO AUTO
ASPECT
CANCEL QUICK
MENU
ENTER
Q
1 2 3 4
4
ቢ Press down on the lens unit until a “click” is heard
and the lens unit locks.
ባ Slide the lens shutter to the right to close it.
STANDBY
AUTO
SOURCE
STANDBY
STATUS
PUSH
1
2
STANDBY (button on main unit)