Pioneer Super Tuner III D+ AVH-P7950DVD - Manual (Page 18)

17
Installation
2. Install the unit into the dash-
board. (Fig. 16)
After inserting the mounting sleeve
into the dashboard, then select the
appropriate tabs according to the
thickness of the dashboard material
and bend them. (Install as firmly as
possible using the top and bottom tabs.
To secure, bend the tabs 90
° .)
Fig. 16
3. After installing the unit into the
dashboard, attach the trim ring.
(Fig. 17)
When attaching the trim ring, place the
narrow side of the frame downward.
Fig. 17
DIN Rear-mount
Installation using the screw holes on
the side of the unit
• Fastening the unit to the factory
radio mounting bracket. (Fig.
18) (Fig. 19) (Fig. 20)
Select a position where the screw holes
of the bracket and the screw holes of
this product become aligned (are fit-
ted), and tighten the screws at 2 places
on each side. Use any of binding
screws (4 mm
× 3 mm), binding
screws (5 mm
× 6 mm) or flush sur-
face screws (5 mm
× 6 mm), depend-
ing on the shape of the screw holes in
the bracket.
*1 Use binding screws (4 mm × 3 mm) only.
Fig. 18
*1
*1
*1
*1
Trim ring
Rubber bush
Screw
Dashboard
Side bracket
182
53
Mounting sleeve
Screw (2 mm
× 3 mm)