Precor AMT 835 - Manual (Page 81)

Setting Up the Console
27
Product Value Information provided
All UPPER BASE SW
PART NUMBER
Upper base application software version
All LOWER BASE
SW PART
NUMBER
Lower application software version
All METRICS
BOARD
Software number on the Metrics Board
AMT STRIDE DIAL SW
PART NUMBER
Stride Dial software number
All SERIAL NUMBER Used to determine exact model and type
of equipment
All USAGE LOG
•
The number of times each program
has been used and displays the
associated cumulative minutes.
•
Helpful in determining user
preferences in program selection.
All EVENT LOG Displays any event codes that may have
been detected by the software. For more
information, refer to Event Log.
Event Log
The event log holds a maximum of 30 events. After the log
reaches 30 events, older events are erased to make room for
newer ones.
Each event log entry contains the following information:
 Event number
 Odometer value when the event occurred
 Hour meter value at the time the event occurred
 Current drawn by the motor when the event occurred
(treadmill only)
The following table contains a list of events detectable by the
software.
Table 5. Event log numbers and descriptions
Event
Number
Description of Event
00 Upper PCA memory location event
02 RAM location event
03 EEPROM checksum event
05 Depressed key at power up