Pioneer FH-P6200 - Manual (Page 5)

! Remove the batteries if the remote control is
not used for a month or longer.
! Do not attempt to recharge the supplied bat-
teries.
! Do not mix new and used batteries.
! If the event of battery leakage, wipe the remote
control completely clean and install new bat-
teries.
! When disposing of used batteries, please
comply with governmental regulations or en-
vironmental public institutions rules that
apply in your country/area.
Using the remote control
Point the remote control in the direction of the
front panel to operate.
Important
! Do not store the remote control in high tem-
peratures or direct sunlight.
! The remote control may not function properly
in direct sunlight.
! Do not let the remote control fall onto the
floor, where it may become jammed under the
brake or accelerator pedal.
! When the remote control is not in use, attach
it firmly to the provided mounting base.
! If you press FUNCTION on the remote control
while pressing BAND at the same time, the re-
mote control will not function properly. To can-
cel this setting, press AUDIO on the remote
control while pressing BAND at the same
time to return to the previous setting.
Resetting the microprocessor
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
% Press RESET on the head unit with a
pen tip or other pointed instrument.
RESET button
Setting the display angle
You can adjust front panel angle for easier op-
eration.
WARNING
! Do not use with the front panel left open. If
you do leave it open, it may result in injury in
the event of an accident.
! Be careful not to catch your finger in the front
panel when it is opening or closing.
% Press ANGLE to change the angle.
Each press of ANGLE changes the angle.
Before You Start
En
5
English
Section
01