Philips FR965 - Manual (Page 20)

20
English
PLAYBACK, RECORDING
1 Press POWER / STANDBY to switch on the receiver.
2 Turn SOURCE SELECTOR to select a source.
y The name of the source is displayed.
• You can select the FRONT AV/GAME input by pressing
FRONT AV (FR 975, MX 980D only).
3 Start playback of the source as usual.
• Turn VOLUME to adjust the volume.
y
VOLUME and the volume level between 0 and 50 is
displayed.
1 Press BASS or TREBLE.
y
BASS or TREBLE and the actual value are displayed
briefly. Then
TURN VOLUME KNOB TO CHANGE is
scrolled.
2 Turn VOLUME to adjust the bass or treble.
y
BASS or TREBLE and the actual value are displayed.
Note: If VOLUME is not turned within 5 seconds or if any
other control is used, the bass or treble adjustment is
switched off.
FR 965, MX 960D only:
• Press ±SOUND on the remote control to scroll through
the built-in smart sounds:
MOVIE, SPEECH, MUSIC,
MULTIMEDIA and PERSONAL. (PERSONAL is the
userdefined bass and treble setting.)
y SMART SOUND is displayed and the name of the chosen
sound profile is scrolled once if smart sound is on.
FR 975, MX 980D only:
• If a subwoofer is connected, press SUBW. ON/OFF to
increase the bass performance.
Note: In case of digital surround sound, a subwoofer signal
will only be available when supported by the source
material.
• Press LOUDNESS to switch on or off loudness.
y LOUDNESS is displayed if loudness is on.
If you wish to record from a source you must select it with
SOURCE SELECTOR. The incoming signal is reproduced by all
audio and – if the source includes a video signal – video
outputs of the receiver. The sound settings do not affect the
recording.
1 Turn SOURCE SELECTOR (or press FRONT AV – FR 975,
MX 980D only) to select the source you want to record from.
y The name of the source is displayed.
2 Prepare the desired recording appliance. It must be
connected to one of the outputs of the receiver.
3 Start recording on the recording appliance.
4 Start the playback of the source as usual.
Note: – The audio and video signal of VCR IN is not
reproduced by VCR OUT. The same applies to the
audio signal of CDR/TAPE IN to CDR/TAPE OUT.
– We recommend not to use the digital output
COAX OUT of the receiver to record from an analog
source. Use the analog output CDR/TAPE instead.
– From a source which is connected to the
6 CHANNEL / DVD INPUT audio input cannot be
recorded.
It is possible to connect a digital recorder to the digital output of
the receiver. In this way, all signals coming from the digital
inputs can be recorded directly on the connected audio recorder.
The receiver will also convert all signals coming from the analog
inputs to the digital output.
The receiver can be used to record digitally a multichannel
surround sound audio signal (Dolby Digital or DTS) from, for
example, DVD to CD-R. The receiver will convert the digital
multichannel signal into a stereo signal without loss of relevant
sound information.
Notes: – Do not use the 3D SURROUND feature while making
digital recordings as this will distort the digital
audio signal (FR 965, MX 960D only).
– When recording a Dolby Digital or DTS signal, each
track must be recorded individually.
– Digital recording is not possible when the digital
source material is copy-protected.
Recording from the digital output
Recording from a source
Adjusting the sound
Playing a source