Pioneer PNR 14-150 - Manual (Page 12)

12 © 2006 Pioneer Supply International 12 © 2006 Pioneer Supply International
Site Considerations
WARNING: DO NOT allow unsupervised children or visitors in shop at any time.
Floor Load
The PNR 14-150 has a shipping weight of 560 lbs (254Kg), net weight of 500 lbs (226.8Kg), and a
base footprint of 32" x48".
Working Space
In order to have a safe working environment, there
should be enough space around the machine to
walk around the machine and enough room to plane
material both at the infeed and outfeed sides without
bumping into other people, machines and obstruc-
tions. See Figure 4.
Moving & Placing Planer
The cabinet stand on the PNR 14-150 is equipped with lifting bars (Refer to page 9) to lift and place the plan-
er. When lifting the planer with a forklift, place shop rags or cardboard between the forks and cabinet base so
you do not scratch the paint.
Extension Wings
You will need:
Two Table Extension Wings, 6 x Hex Bolts, 6 x
Lock Washers, 6 x Flat Washers. 4 x Set Screws.
To attach the table extension wings:
1 Install set screws in the holes in the side of the
wings (see Figure 5).
2 Attach the table extension wings to the planer table
with the hex bolts, lock washers, and flat washers,
as shown in Figure 6, but do not fully tighten the
!
Figure 4
Figure 5
Cleaning
The unpainted surfaces are coated with a waxy oil to protect them from corrosion during shipment. Remove
this protective coating with a solvent cleaner or citrus-based degreaser to clean thoroughly, some parts may
need to be removed. For optimum performance from your machine, make sure you clean all moving parts
or sliding contact surfaces that are coated. Avoid chlorine-based solvents, such as acetone or brake parts
cleaner, as they may damage painted surfaces should they come in contact. Always follow the manufacturer’s
instructions when using any type of cleaning product. These items are coated and must be cleaned:
Cutter head, Table, Feed Rollers, and Extension Wings.
WARNING: Gasoline and petroleum products have low flash points and could cause an explo-
sion or fire if used to clean machinery. DO NOT use gasoline or petroleum products to clean the
machinery. Many of the solvents commonly used to clean machinery can be toxic when inhaled or
ingested. Lack of ventilation while using these solvents could cause serious personal health risks
or fire. Take precautions from this hazard by only using cleaning solvents in a well ventilated area.
!