Patton electronic 1082/144 User Manual
User, Manual, Idsl modem with v.34 or x.21 interface
Table of contents
Document Outline
- 1.0 Warranty Information
- 2.0 General Information
- 3.0 Configuration
- 3.1 Configuring the Hardware DIP Switches
- Configuring DIP Switch S1
- Switches S1-1 and S1-2: Data Rate
- Switch S1-3: Data Set Ready during Line Loopback Test
- Switch S1-4: Must be set to the ON position (Reserved).
- Switch S1-5: Asynchronous/Sync Operation
- Switches S1-6 and S1-7: System Clock Mode
- Switch S1-8: Response to RDL Request
- Configuring DIP switch S2
- Switches S2-1: 19.2 kbps or 144 kbps Synchronous Rate Enable
- Switch S2-2: Front Panel Switch Disable
- Switches S2-3: Response to Local Line Loop Requests from DTE
- Switches S2-4 and S2-5: Not Assigned
- Switch S2-6: Response to RDL Request from DTE
- Switch S2-7: Compatability Mode
- Switch S2-8: Not Assigned
- 3.1 Configuring the Hardware DIP Switches
- 4.0 Installation
- 5.0 Operation
- Appendix A Model 1082 Specifications
- Appendix B Model 1082C and 1082D Factory Replacement Parts and Accessories
- Appendix C Model 1082C and 1082D Interface Pin Assignments
- Appendix D Model 1082C and 1082D Interface Pin Assignments
- Appendix E Model 1082C and 1082D Interface Pin Assignment