Planet Technology WAP-4000A - Manual (Page 8)

PLANET WAP-4000A User Manual
- 4 -
Chapter 2 Hardware Installation
Before you proceed with the installation, it is necessary that you have enough information
about the WAP-4000A.
1. Locate an optimum location for the WAP-4000A. The best place for your
WAP-4000A is usually at the center of your wireless network, with line of sight to all of
your mobile stations.
2. Assemble the antennas to WAP-4000A. Try to place them to a position that can best
cover your wireless network. The antenna’s position will enhance the receiving
sensitivity.
3. Connect RJ-45 cable to WAP-4000A. Connect this WAP-4000A to your LAN
switch/hub or a single PC.
4. Plug in power adapter and connect to power source. After power on, WAP-4000A
will start to operate.
Note: ONLY use the power adapter supplied with the WAP-4000A. Otherwise, the product
may be damaged.
If you want to reset your WAP-4000A to default settings, press the Reset button 5
second. And then wait for 10 seconds for WAP-4000A to reboot.