Setting remote control code type 85, Setting remote, Setting remote control code type – Pioneer AVH-P6500DVD User Manual

Page 85: Setting up the dvd player, Changing the level, If you forget your code number

! LEVEL 1 Playback of discs for children

only is possible

Notes

! We recommend to keep a record of your code

number in case you forget it.

! The parental lock level is recorded on the disc.

You can confirm it by looking at the disc pack-
age, included literature or on the disc itself.
With discs that do not feature a recorded par-
ental lock level, you cannot use parental lock.

! With some discs, parental lock operates to

skip certain scenes only, after which normal
playback resumes. For details, refer to the
discs instructions.

Changing the level

You can change the set parental lock level.

1 Touch SETUP and VISUAL and then

touch PARENTAL.

2 Touch 09 to input the registered code

number.

3 Touch ENTER.

This enters the code number, and you can now

change the level.

# If you input an incorrect code number, the
icon

is displayed. Touch C and input the cor-

rect code number.
# If you forget your code number, refer to If you
forget your code number on this page.

4 Touch any of 18 to select the desired

level.

The new parental lock level is set.

If you forget your code number

Refer to Changing the level on this page, and

touch C 10 times. The registered code number

is canceled, letting you register a new one.

Setting remote control

code type

When the remote control operation switch is

set to DVD, changing the remote control code

type enables you to operate the Pioneer DVD

player by the supplied remote control. There

are three remote codes, code type A, code

type B and code type AVH. When using this

unit with a multi-DVD player (e.g. XDV-P9II),

select code A. When using this unit with a

DVD navigation unit, select code B. When

using this unit only, select code AVH.

1 Set the remote control selection switch

on the left side of the remote control to

the appropriate position with a pen tip or

other pointed instrument .

! If you select AVH mode, there is no need to

take the following procedure.

! If you select A/B mode, take the following

procedure and change the code type to the
appropriate type.

2 Press 7 and 0 on the remote control si-

multaneously to change the code type.

Initially, the code type is set to A. Each time

you press 7 and 0 simultaneously on the re-

mote control the code type switches between

A and B.

Setting up the DVD player

Section

Setting

up
the
DVD

player