Pioneer AVH-P6500DVD - Manual (Page 79)

Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Touch A.MENU and AUDIO and then
touch NEXT.
2 Touch SP LEVEL.
3 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
FRONT L (front speaker left)CENTER (center
speaker)FRONT R (front speaker right)
REAR R (rear speaker right)REAR L (rear
speaker left)SUB WOOFER (subwoofer)
# You cannot select speakers whose size is set
OFF.
4 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d increases or de-
creases the speaker output level. +10 10 is
displayed as the level is increased or de-
creased.
Note
To adjust the speaker output levels at this mode is
the same as making the speaker output levels at
TEST TONE. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Touch A.MENU and AUDIO and then
touch NEXT.
2 Touch TEST TONE.
3 Touch START to start the test tone out-
put.
The test tone is output. It rotates from speaker
to speaker in the following sequence at inter-
vals of about two seconds. The current set-
tings for the speaker over which you hear the
test tone are shown in the display.
FRONT L (front speaker left)CENTER (center
speaker)FRONT R (front speaker right)
REAR R (rear speaker right)REAR L (rear
speaker left)SUB WOOFER (subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
# You can also start the test tone output by mov-
ing the joystick up.
# The settings do not appear for speakers
whose size is set OFF.
4 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d increases or de-
creases the speaker output level. +10 10 is
displayed as the level is increased or de-
creased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
5 Touch STOP to stop the test tone out-
put.
# You can also stop the test tone output by mov-
ing the joystick down.
Notes
! If needed, select speakers and adjust their ab-
solute output levels. (Refer to Adjusting the
speaker output levels on this page.)
! To adjust the speaker output levels at this
mode is the same as making the speaker out-
put levels at SP LEVEL. Both provide the same
results.
DigitalSignalProcessor
En
79
Section
16
DigitalSignalProcessor