Printek FormsPro 4300 - Manual (Page 31)

Operation
Page 3-11
Function Possible Values Description
DTR: Power*, Online, or Busy Selects the condition to be reflected
by the DTR signal (pin 20 of the
RS-232C interface). Available
only when the RS-232C interface is
installed and Serial is selected.
XON/XOFF: Off* or On Enables or disables the
transmission of the XON and
XOFF characters from the printer
to the host to control data flow to
the printer. Not available when
Parallel, or CX/TX is selected.
ETX/ACK: Off* or On Enables or disables the ACK
response to receipt of the ETX
character. Not available when
Parallel, or CX/TX is selected.
Auto CR: Off* or On Enables or disables automatic
Carriage Returns (CR) when a Line
Feed (LF), Vertical Tab (VT), or
Form Feed (FF) is received.
Auto LF: Off* or On Enables or disables automatic Line
Feeds (LF) when a Carriage Return
(CR) is received.
Long Line: Wrap* or Trunc Sets whether characters beyond the
right margin will be wrapped to the
next line or truncated.
Left Edge: Fixed or Float* Sets whether the left edge of the
line will be printed 1/2 inch from
the detected edge of the paper or be
fixed at position “0” on the ruler.
FF at TOF: Yes* or No Sets whether Form Feeds (FF) will
be performed when received from
the host computer if the paper is
already positioned at the top of
form (TOF).
Scroll Delay: 0, 1*, 2 through 15 Sets the number of seconds to delay
before scrolling the top of form to
the tear bar when the printer is idle
and a form boundary has been
reached.