Printek FormsPro 4300 - Manual (Page 27)

Operation
Page 3-7
Function Possible Values Description
Form #: 0 through 9 Allows you to select the desired
form. The printer defaults to the
currently selected form.
F# Path: Front, Center, or Rear Sets the tractor path to be used for
the current form. This function is
available only on the
FormsPro 4503.
F# Auto Cut: Yes or No* Available only when the optional
FormsCutter is installed. See
FormsCutter manual for additional
information.
F# CPI: 10*, 12, 13.3, 15, 16.74,
17.14, or 20 Sets the character pitch in
Characters Per Inch.
F# Left Mar: 0* through 134 Sets the left margin in columns
(characters) from the leftmost print
position. Column width is based
upon CPI. The left margin must
be less than the right margin.
F# Right Mar: 1 through 255, or MAX*. Sets the right margin in columns
(characters) from the leftmost print
position. A value of MAX sets the
margin to the rightmost print
position, regardless of CPI. The
right margin must be greater than
the left margin.
F# LPI: 6* or 8 Sets the line pitch to 6 or 8 lines
per inch.
F# Length: 1 through 227 (66*) Sets the form length in lines at the
current line pitch. For example:
for an eleven inch form, enter 66 if
you are using six lines per inch or
88 if you are using eight lines per
inch.
F# Top Mar: 0* through 255 Sets the top margin by adding the
specified number of lines to the
top of the form.
F# Btm Mar: 0* through 255 Sets the bottom margin in lines
lines from the bottom of the form.