Philips SBC RU 240 - Manual (Page 5)

N o t e
- The search time averages about 90 seconds. (Maximum search
time is 5 minutes for TV, 2 minutes for VCR, 4 minutes for SAT
and 5 minutes for AUX).
- Autosearch stops automatically after all codes have been
tested.
MAKE A NOTE OF YOUR CODE!
A d v i c e
Carefully read the complete procedure before starting!
Note the code inside the battery case and in the codelist of
this booklet. This may be useful if you ever need to set up the
SBC RU240 again. You used the auto search procedure or you
forgot to note the code after set up? No problem! You can still
‘read out’ the code from the remote:
1
Make sure you have selected the right mode with the mode
selector key.
2
Press and release keys 1 and 6 simultaneously.
Important: after pressing the keys, you have to release them
immediately!
– The green LED lights up.
3
Press the the previous program key.
– The green LED goes out.
4
Press key 1 and count the number of times the green LED
flashes. This is the first digit of the 3-digit code. (No
flashes means the digit is zero.)
5
Press key 2 and count the number of flashes for the second
digit.
6
Press key 3 and count the number of flashes for the third
digit.
7
Note the code.
ADVANCED TIPS AND TRICKS
A d v i c e
Carefully read the complete procedure before starting!
Changing the device keys
With the mode selector it is possible to select 4 categories of
devices you want to operate. Each category (TV, VCR, SAT and
AUX) is meant to operate a specific group of equipment:
TV VCR SAT AUX
tv vcr sat vcr
cable
Once you have programmed the functions of a device in one
of the categories, it is not possible to program another device
in the same category. There is, however, a solution in case
you want to program two devices in the same category
(2 TV’s, VCR’s, etc.). The following example explains how.
Instructions for use
5
English