Patton electronic SMARTNODE 4630 - Manual (Page 45)

Ethernet 45
SmartNode 4630 User Manual C • Cabling
Ethernet
Ethernet devices (10Base-T/100Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All
Ethernet ports on the SN4630 are Auto-MDX use any straight or crossover cable to connect to hubs, switches,
PCs or other devices.
Figure 10. Typical Ethernet straight-through cable diagram
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
When this device is used in North America, it shall be connected
to a Network Termination Device and not connected directly to
an outside POTS line.
CAUTION
CAUTION
Hub
RJ-45, male
1
2
3
6
RJ-45, male
1
2
3
6
Straight-through cable
Note: Other pins are not used.