Planet Technology Pre-N Wireless Router WNRT-610 - Manual (Page 18)

3.2 LAN
You can configure WNRT-610 DHCP server function in this screen. When configuration is completed,
please click “Save” to save and restart WNRT-610.
IP address: Set for the Wireless Broadband Router, as seen from the local LAN. Use the default value
unless the address is already in use or your LAN is using a different IP address range. In the latter case,
enter an unused IP Address from within the range used by your LAN.
Subnet Mask: The default value 255.255.255.0 is standard for small (class "C") networks. For other
networks, use the Subnet Mask for the LAN segment to which the Wireless Broadband Router is
attached (the same value as the PCs on that LAN segment).
DHCP Server: Click to enable the function.
Start IP: Type an IP address to serve as the start of the IP range that DHCP will use to assign IP
addresses to all LAN devices connected to the WNRT-610.
End IP: Type an IP address to serve as the end of the IP range that DHCP will use to assign IP
addresses to all LAN devices connected to the WNRT-610.
- 12 -