Palm CompactFlash 10/100 - Manual (Page 7)

CompactFlash Ethernet LAN Card is then
turning into a conventional PCMCIA type II
PC Card.
2. Align the PC Card toward the PC Card slot
with brand label facing upward, as shown
below.
Notebook
Connecting to the Network
1. Connect unshielded twisted pair (UTP) cable
to the RJ-45 connector in the Attached Port of
the CompactFlash card before loading any
network driver.
For operation in the 10Mbps (10Base-T)
Ethernet network, Category 3, 4 or 5
unshielded twisted pair (UTP) cable could be
used to connect between the CompactFlash
Ethernet LAN Card and a 10Mbps hub or
switch.
Note
To remove the CompactFlash Ethernet LAN Card,
please refer to the Compact Card removal instruction
in the document for your PDA/Palm PC.
- 5 -