Powering up the system, Selecting the input mode, Programming channels for tv/catv – PYLE Audio PLVW20T User Manual
Page 15: Selecting channels, Follows; tv mode: for receiving tv channels 2-69
14
Powering up the system
1. Press and hole the POWER On/Off button on the remote
until the green LED on the front of the monitor is illuminated.
The On Screen Display will show the position of the system
at the time it was last turned off (for example, if you were
watching CATV Channel 38 when you last turned the power
off, the system will display "CATV CH 38").
2. Turn off the system by pressing the POWER On/Off button
on the remote. The screen will go dark and the green LED
will go out; the tuner unit will be in STANDBY mode.
Selecting the input Mode
Your Video Tuner can switch between four different
video sources using the remote control. These modes are as
follows; TV Mode: for receiving TV Channels 2-69
CATV Mode: for receiving satellite dish, Cable or other
broadcast source video
AV1:External audio and video inputs for DVD,VCR or video game
AV2:External audio and video inputs for DVD,VCR or video game
Programming Channels for TV/CATV
The tuner system can memorize channels in both TV
(VHF and UHF) mode and CATV mode in two independent
memory sections. To memorize channelss in either mode,
press the AUTO PROG button on the remote-the tuner will
begin scanning all of the available channels and put them
int memory. During this programming cycle, the screen will
display "AUTO"in the upper left corner.
IF you wish to interrupt the auto programming mode. press
the Channel button. Interrupting in this manner is not
recommended, however, because it will not program all
channels properly.
Selecting Channels
Use the Channel and buttons for selecting channels. If the
unit has been auto programmed, the and buttons will step
up or down through only the memorized channels. Pressing
and holding the or buttons in the CATV mode will cause the
unit to step automatically through all available channels until the
Button is released; pressing and holding these buttons in TV
mode will cause the tuner to "seek" any air channel which can
be received.
TV/CATV
TV/AV
MUTE
POWER
1
2
3
4
5
6
7
8
9
0
FM/AM
SETUP
Monitor
DN
-
MODE
UP
+
FUNC
VOL
CH
TV/CATV
TV/AV
MUTE
POWER
1
2
3
4
5
6
7
8
9
0
FM/AM
SETUP
Monitor
DN
-
MODE
UP
+
FUNC
VOL
CH
TV/CATV
TV/AV
MUTE
POWER
1
2
3
4
5
6
7
8
9
0
FM/AM
SETUP
Monitor
DN
-
MODE
UP
+
FUNC
VOL
CH
TV/CATV
TV/AV
MUTE
POWER
1
2
3
4
5
6
7
8
9
0
FM/AM
SETUP
Monitor
DN
-
MODE
UP
+
FUNC
VOL
CH