PYLE Audio PLVW20T - Manual (Page 13)

12
Tuner Installation and electrical connections
1. Find a suitable location for the tuner unit and mount it securely in place. Be
sure to place it in an area away from moisture and dirt, and where incoming
cables will not be walked on or pulled accidentally.
2. Make all required audio, video and power connections to the appropriate
connectors on the tuner as indicated in the drawing below to suit your system
installation. Install the infrared remote eye in a location you know will be
Installation in line-of-sight with the remote control use location
Please note that the drawing below describes connections for all system
possibilities and your particular system may vary from this.
For example, if your car radio lacks AUX line level input jacks, you will be
unable use the A/V VIDEO OUT jacks to provide audio. In this case, you
can take advantage of the built-in FM transmitter in the tuner box which
will broadcast the audio to your car radio instead.
You may chose to use just the car radio antenna, just the diversity antenna
system, or both. Similarly, you system may include one A/V input source or
two. You may or may not have an additional viewing monitor.
IR Interface cable
Installation