Planet Technology LCD MONITOR 170S8FS - Manual (Page 21)

18 19
Warm Start trap: to set the trap when the device had been reset (default = enable).
Authentication Fail Trap: to set the warning trap when the community name of the
device and workstation are different (default = enable).
Power Fail Trap: to set the Power Fail Trap (default = enable).
Fan Fail Trap: to set the Fan fail trap (default = enable).
MC Plug-in Trap: to set the trap when a Media Converter Module has been plugged in
(default = enable).
MC Pullout Trap: to set the trap when the Media Converter Module has been pulled out
(default = enable).
MC Broken trap: to set the trap when the Media Converter Module was broken (default
= enable).
MC Link up trap: to set the trap when a linking is connected (default = enable).
MC Link down trap: to set the trap when a linking is disconnected (default = enable).
MC Active Slot Xchg trap: to set the trap when there is a redundant function activated
(default = enable).
MC Active Slot Lose trap: to set the trap when the redundant function is fail (default
= enable).
4.2.2.4 Location Setting
Assign each slot’s location or name in order to remember in where each slot was
connected.