Pride Mobility 1400 - Manual (Page 23)

Go-Chair www.pridemobility.com 23
TOGGLE LATCH
RELEASE BUTTON
PEG
Figure 12. Toggle Latch Open
Figure 11. Toggle Latch Closed
Figure 13. Rear Section Positioning Figure 14. Align Frame Sections
Figure 15. Lift Front Section
CURVED LOCKING
BRACKET
Assembly
1. Tilt the Go-Chair rear section backward onto the anti-tip
wheels. See figure 13.
2. While holding the front section parallel to the floor, align the
curved locking brackets on the front section with the corre-
sponding pegs on the rear section. See figure 14.
3. Grasp the foot platform and lift the front section to a vertical
position on the rear section. See figure 15.
4. Secure the toggle latch to the locked position. See figure 11.
WARNING! Ensure that the toggle latch buckle is
securely fastened to the retainer before
operating the Go-Chair.
5. Grasp the foot platform and lower the assembled frame sec-
tions to the floor.
6. With the battery box tilted forward slightly, place it on the
power base, then push the back of the battery box down until
it is firmly in place.
7. Install the seat and plug the controller into the power base. See
figure 6.
I V . A S S E M B L Y / D I S A S S E M B L Y