Pioneer PDP-502MXE - Manual (Page 15)

11
En
Installation and Connections
Français
English
Audio connections
Before making connections, be sure to check that the
component’s power and the unit’s main power is off.
Connecting the speakers
This unit is equipped with speaker output jacks for
connection to the speaker system (not supplied) specially
designed for use with this unit. Refer to the illustrations
below when making connections to the speaker terminals
on this unit.
Note
When making speaker connections, be sure to match the
polarities (+ and –) of the speaker terminals on this unit and the
corresponding terminals on the speakers. If the polarity is
reversed, the sound will be unnatural and lack bass.
Twist exposed
wire strands
together.
Push tab to the open
position, and insert the
wire. Then, close tab
firmly to secure the wire
in place.
Installation and Connections
10 mm
INPUT3
INPUT4
Audio input jacks Sound output
Pin jacks
(L/R)
Stereo mini jack
(L/R)
Sound of the selected input
is output from the
• SPEAKER terminals
• Stereo mini jacks (L/R).
Video
input
Making connections to the audio inputs on this
unit
This unit features two audio inputs and one audio output.
The following chart shows the inputs and the
corresponding audio input jacks.
Control cord connection
When control cord connections are made, remote control
operation of connected PIONEER components that bear
the
Î logo mark is done through the remote sensor on
this unit.
When the connection is made to the CONTROL IN jack
on another unit, the remote sensor of that component will
no longer receive signals. Point the remote control unit of
the connected component at the remote control sensor
on this unit to control.
Notes
÷ Make sure the power is turned off when making
connections.
÷ Please complete all component connections before
making control cord connections.
The control cables (not
supplied) are monaural
cables with mini plugs (no
resistance).
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN OUT
Main unit